QLN AUDIO PRESTIGE ONE
Coppia di diffusori da scaffale
Codice: 65008000
Tutti i nostri prodotti nuovi sono coperti da garanzia italiana. L'usato invece è coperto da 6 mesi di garanzia vedi le condizioni.
*Supporti opzionali € 970,00
*Supporti opzionali Walnut Piano € 1100,00
Introduction
The Qln Prestige One is a reference caliber monitor
commensurate with the performance level of the award-winning Prestige
series. In keeping with Qln’s truncated cabinet design, the Prestige One
features the same minimal baffle area, time alignment, and dampening
technology found in the Signature 3 with even greater optimization
establishing a new performance benchmark.
Design details
Crossover
We
utilize the same constant impedance crossover technology found in the
rest of the Prestige series with fine tuning for the compact two-way
design of the Prestige One. We have increased dynamics and even SPL by
using lower loss coils to the woofer. All coils are air core, and all
capacitors are of polypropylene material.
All coils are baked so the wires are glued together to reduce internal vibration.
The
constant impedance crossover produces an even impedance response that
eases the load an amplifier sees (especially tube amps) providing better
phase coherence for the driver. The crossover is hard wired for best
contact between components with as few contact points as possible. Every
component is soft glued to increase damping and minimize vibrations.
Cable
We
have designed our own internal wire for the Prestige series. Pure
copper solid core wires wrapped side by side around a polypropylene core
to reduce multi connections between each wire core.
Dual (+) and
(-) cable parts are baked in a damped rubber like acoustic isolation
body to reduce vibration and friction between each part. Isolation
material are pure polypropylene without color material to avoid negative
effect of color in the isolation material.
Speaker connectors
Top
grade WBT Nextgen® connectors with minimal connection materials made of
silver/copper are used to ensure the lowest distortion and signal loss
possible. Normally we only using pure copper material. The reason for
using silver plated connectors instead of pure copper is that while
silver also oxidizes it provides a purer long term connection surface.
And while the commonly used gold-plated surface is good for a
non-oxidizing it is not best for sound quality.
Drivers
The
bass/midrange and treble drivers have been specifically selected and
custom developed by industry renowned Danish driver manufacturer Scan
Speak offering the latest in 21st century advanced driver technology.
The uniquely coated Kevlar bass/midrange driver with its built-in copper
ring in the magnet system offers symmetric drive and higher midrange
dynamics while also suppressing intermodulation distortion. The result
is remarkable vocal reproduction and astonishing micro/macro dynamics
from a compact 2-way speaker design. The unique Illuminator tweeter also
offers excellent imaging at all listening positions. Its large roll
surround and textile dome diaphragm provides a flat frequency response
above 30 KHz with outstanding off-axis dispersion. The unique AirCirc
magnet system and its rear chamber further reduce reflections and
resonances.
Impedance: 8 ohms
Amplifier requirements: 25-250 Watt RMS
Tweeter: 25mm wide surround, AirCirc magnet, soft dome
Woofer: 177mm Kevlar® cone
Sensitivity: 87,5 dB SPL 1 Watt 1m
Low frequency performance: -3dB 42Hz
Cabinet: Qboard® Technology
Terminal: WBT Single wire
Dimensions (HxWxD): 390x265x372
Weight: 14,0 kg each
Finish: Walnut Piano, Walnut matte, White satin